|
|
|
|
|
|||||
   International
ShippingCompany
ProfileMail,
fax form                    
      |
Bendable Bright Light is great for making sewing much easier by putting light exactly where you need it. The "NO BATTERIES NEEDED" and quality metal flexible arm and metal light housing with a single LED make this a must have for all your sewing projects.
|
MFG: Dream World Inc |
MFG: Dream World |
The Bendable Bright Light is constructed with a quality metal flexible
arm and metal light housing with a single LED with and 8ft low voltage
power cord. The light snaps into the non-magnetic mount and won't harm
electronics and adhesive holds mount on machine. Energy efficient LED,
100,000 light hours, 120 volts, no batteries needed.
90 Day Warranty
To choose the best placement on your sewing machine, please look at your
machine carefully. Generally speaking, the best place to mount the light
is on the LEFT end of the machine. There are many things to consider:
the presser foot lifter, thread cutters, tension dials, thread guides
and the thread take-up lever. Other things to consider may be the handle,
any doors or covers that may open and close, the spool to needle thread
path and any curves and angles etc. Some of these things may not apply
to your brand of machine.
Clean the mounting surface with rubbing alcohol. Let them dry thoroughly.
Insert the light base into the mounting bracket before attaching it to
the machine. Place the light bracket release tab at approximately a 12:00
to 2:00 o'clock position. If the machine is curved, get the majority of
the adhesive attached. Being careful not bend or bread the bracket, peel
the protective backing from the adhesive and press firmly.
For best placement of the cord clips run the cord along the back of the
machine above the presser foot lifter, keeping clear of the thread path,
belts and motors etc.
Separate the clips and the adhesive pieces from each other. Clean the mount surface the clips with rubbing alcohol and let them dry thoroughly.
Peel one side of an individual adhesive square and apply it to the back
of one clip. Press firmly. The cord should slide into the clip from the
top. Then peel the other side and apply it to your clean machine surface.
Press firmly. Repeat for the remaining clips.
To remove or transfer light to another machine apply a few drops of GOO GONE®, let it set for 2 minutes to soften adhesive. Lift the clips/bracket slowly, once removed set aside with the adhesive side up for 15 minutes. After the GOO GONE® has evaporated the clips/bracket can be reapplied.
|
|
|
| |||||||||||||||||||||||||
Related
Items
